A: Yes. If you are supplying prototype parts to an OEM, you still must comply with CQI-11 for the prototype run. Partial compliance is not acceptable.
| Standard | Focus Area | Key Difference | | :--- | :--- | :--- | | | Plating (Zinc, Chrome, Anodizing, etc.) | Focuses on bath chemistry, rectifiers, and hydrogen embrittlement. | | CQI-9 | Heat Treating | Focuses on furnace uniformity, temperature controls, and quench oils. | | CQI-12 | Coating (Paint, Powder) | Focuses on spray parameters, film thickness, and adhesion cross-hatch. | | CQI-15 | Welding | Focuses on weld parameters, gas flow, and operator certification. | | CQI-17 | Soldering | Focuses on electronic assembly and reflow profiles. | aiag cqi-11 pdf
A: At minimum, annually. However, most high-volume OEMs require a fresh assessment every 6 months or after any major process change (e.g., new tank chemistry, new rectifier). A: Yes
Introduction: What is CQI-11? In the fast-paced world of automotive manufacturing and supply chain management, quality is non-negotiable. One wrong component can lead to catastrophic recalls, brand damage, and financial ruin. To standardize quality across billions of parts, the Automotive Industry Action Group (AIAG) developed a series of Continuous Quality Improvement (CQI) standards. Among the most critical—and most frequently audited—is CQI-11: Special Process: Plating System Assessment . | Standard | Focus Area | Key Difference
Print Page