For Arduino Datasheet — Hw 130 Motor Control Shield

Unlike its more powerful successor (e.g., L298N-based shields), the HW-130 focuses on low-voltage, low-current applications where simplicity and direct Arduino pin mapping are paramount.

void setup() stepper.setSpeed(30); // 30 rpm hw 130 motor control shield for arduino datasheet

Approx. 4W (with proper cooling) 3. Pinout & Hardware Layout The HW-130 sits directly on top of the Arduino Uno. It uses the following Arduino digital and analog pins (note that analog pins A0–A5 are broken out for general use ): Dedicated Motor Pins: | Motor | Direction Pin (Arduino) | PWM Speed Pin (Arduino) | |-------|------------------------|-------------------------| | M1 | D12 | D5 | | M2 | D11 | D6 | | M3 | D8 | D9 | | M4 | D7 | D10 | Unlike its more powerful successor (e

![HW-130 Shield Pictorial Representation] | Parameter | Value / Range | |-------------------------|---------------------------------------| | Driver IC | L293D (x1) | | Input Voltage (VCC) | 4.5V to 12V DC (external power) | | Logic Voltage | 5V (from Arduino) | | Max Continuous Current | 600 mA per channel (peak: 1.2A) | | Number of DC Motors | Up to 4 (or 2 with speed/direction) | | Stepper Motors | 1 bipolar (unipolar not supported) | | PWM Channels | 4 (pins 5, 6, 9, 10 on Arduino) | | Thermal Shutdown | Yes (built into L293D) | | Flyback Diodes | Integrated in L293D (internal) | | PCB Size | 68.5mm x 53.3mm (standard Uno shield) | | Stackable | Yes (with pin headers) | Pinout & Hardware Layout The HW-130 sits directly

1. Introduction The HW-130 is a popular, low-cost motor driver shield designed for Arduino Uno, Arduino Leonardo, and similar compatible boards. It is based on the L293D quadruple half-H driver IC, making it ideal for driving small DC motors, bipolar stepper motors, and even solenoids. This shield is a clone or derivative of the well-known Adafruit Motor Shield V1 design, and it offers an entry-level solution for robotics and mechatronics projects.