Liebert Hipulse D Ups | Manual

| | Possible Cause (per manual) | Recommended Action | | --- | --- | --- | | Rectifier Fault (Red LED) | Mains phase loss, SCR shorted, or DC bus overvoltage. | Check input fuses. Measure voltage on L1,L2,L3. If okay, call service (DC bus requires trained personnel). | | Inverter Limit | Overload >110% for >10 minutes or short circuit on output. | Reduce load. Check for downstream breaker trip. If output shorted, transfer to bypass immediately. | | Battery Low | Battery voltage below end-of-discharge threshold (typically 1.75 V/cell). | Prepare for shutdown. If mains absent, system will cut out in 1-2 minutes. Replace batteries. | | Fan Failure | Tachometer signal missing from one or more fans. | Check fan fuse. Replace fan module (part number listed in manual). System can run briefly but derate. | | Parallel Redundancy Lost | In a parallel system, one unit has tripped its breaker or failed. | Identify the isolated unit. Use manual to check inter-unit cable (CAN/RS485). Restart slave unit. | Chapter 8: Maintenance Schedules Extracted from the Manual The Hipulse D is industrial-grade and requires regular care. Below is a summary from the maintenance chapter.

The xxx suffix often denotes language (e.g., 100 for English, 200 for French). liebert hipulse d ups manual

| | Description | Typical Revision | | --- | --- | --- | | 51311842-xxx | Hipulse D 10-300 kVA User Manual | Rev A to G | | 51312010-xxx | Installation and Commissioning Guide | Rev B | | 51312011-xxx | Parallel System Operation Manual | Rev C | | 51312012-xxx | Communication Interface Manual (Modbus/SNMP) | Rev A | | | Possible Cause (per manual) | Recommended