Norsok | R001

If you are reusing a carbon steel flange originally bolted to a Monel heat exchanger, the flange likely suffered accelerated galvanic corrosion. R-001 requires you to inspect the interface points , not just the component in isolation.

If you are working on a Norwegian shelf modification project in 2025, assume that R-001 applies. Start your data collection yesterday. And remember: In the world of NORSOK, reuse is not a compromise—it is an engineering discipline. Frequently Asked Questions (FAQ) on NORSOK R-001 Q: Does NORSOK R-001 apply to electrical equipment? A: No. Electrical and instrumentation equipment fall under NORSOK R-002 (Lifting and Transport) or R-003 (Electrical). R-001 is strictly mechanical. norsok r001

A: While NORSOK standards are generally "voluntary" (guidelines), Equinor and the PSA have effectively made them mandatory for all new and life-extension projects on the NCS. If you don't follow R-001, you cannot get a consent to operate. This article is intended for informational purposes and reflects the current NORSOK R-001:2021 revision. Always consult the official standard document and applicable Norwegian regulations (SAFETY Regulations for the NCS) before performing requalification activities. If you are reusing a carbon steel flange

A: Typically, a "Competent Person" with at least 5 years of offshore mechanical integrity experience and specific training in the NORSOK standard. Most operators require a Level III NDT inspector or a Chartered Engineer. Start your data collection yesterday