Virtual Device Serial0 Will Start Disconnected Here

The root cause? The console log from boot clearly showed: "Virtual device serial0 will start disconnected" and "Virtual device serial1 will start disconnected" . The student had never connected the cables from the router to the Frame Relay switch.

Always read the console boot messages. That "disconnected" line is not a warning; it is a direct status report. Frequently Asked Questions (FAQ) Q: Does this happen on real Cisco hardware? A: No. Real hardware will show "%LINK-3-UPDOWN: Interface Serial0/0, changed state to down" if no cable is plugged in, but it will never announce "virtual device." virtual device serial0 will start disconnected

[[router R1]] image = c7200.bin serial0 = "R2 serial0" This tells Dynamips to create a direct serial cable between the two virtual devices on boot. A common mistake is logging into the router and typing: The root cause

In a real Cisco router, Serial interfaces use . If no cable is plugged in, the interface remains "down/down." However, emulators are not real circuits. If an emulator tried to auto-detect every possible connection at boot, it would slow down the entire lab startup process. Always read the console boot messages

config t interface serial0 no shutdown After this, show ip interface brief still shows Serial0 down/down .

If you have ever fired up a Cisco router in Dynamips , GNS3 , EVE-NG , or Cisco Packet Tracer , you have likely seen the console output slowly crawl by until it halts at a seemingly concerning line: "Virtual device serial0 will start disconnected" For many students, this message triggers an instinct to panic. Is the router broken? Is the image corrupted? Will Serial0/0 ever come up?